Cordless Headset Leds; Using The Cordless Devices Application; Low Battery Level - Mitel 5360 User Manual

Cordless Headset LEDs

There are two LEDs associated with the cordless headset:
A blue LED on the headset indicates the headset status
x
A green LED in the headset charging cradle indicates battery status
x
LED Color
Blue
(on headset)
Green
(on cradle)
Blinking: LED is On and Off for equal amount of time
Winking: LED is On for a short period of time and Off for a longer period

USING THE CORDLESS DEVICES APPLICATION

The Cordless Devices Application provides access to module information and pairing for
hand- or headsets.
To access the Cordless Devices Application, do one of the following:
Press the Menu
x
Press a feature key you have programmed as the Cordless Devices Application key.
x
Note: When the pairing button on the Cordless Module is pressed, or when the battery
level of a cordless accessory is critically low, the phone will automatically open the
Cordless Devices Application.

Low Battery Level

When the battery of a cordless device reaches a near-critical level, the phone displays a
warning. Until the battery is recharged (or until it becomes fully discharged), the warning is
repeated at each new call made using the Prime Line. To continue with a call while charging
the cordless accessory, switch to speakerphone and then cradle the cordless accessory.
LED State
Solid Headset mic is muted
Blinking Headset is in pairing mode
Winking Active audio path between Headset and Module
Solid for 2 Pairing successful OR
seconds
New battery installed
Off No audio path between Headset and Module OR
Battery is dead
Solid Battery is fully charged
Blinking Battery is charging. Note: It is normal for the headset LED to cycle
between blinking and solid as battery charge is maintained.
Winking Indicates low voltage when headset is uncradled
Off When headset is cradled, indicates battery is not charging.
key and then press Cordless Devices
Indicates
- 87 -
5360 IP Phone – User Guide