Handset/Headset Combinations; Pairing The Cordless Module And Accessories; Pairing A Cordless Accessory With The Cordless Module - Mitel 5360 User Manual

Handset/Headset Combinations

The following combinations of corded and cordless headset and handset are supported on
the 5360 IP Phone:
Corded handset only
x
Corded headset only
x
Corded handset and corded headset
x
Cordless handset only
x
Cordless headset only
x
Cordless handset and cordless headset
x
Corded handset and cordless headset
x
Corded headset and cordless handset
x

Pairing the Cordless Module and Accessories

The cordless headset and handset are optional accessories, ordered separately. Before use,
each must establish communication with the Cordless Module using a procedure called
pairing.
Notes:
An IP telephone can have only one cordless handset and one cordless headset
x
A cordless handset or headset can be paired with only one IP telephone at a time
x
Pairing a new cordless handset or headset with the IP telephone overwrites the
x
configuration of any previous handset or headset
Pairing cannot be performed when the cordless device is already in use.
x

Pairing a Cordless Accessory with the Cordless Module

To pair a cordless accessory:
1. Ensure that the battery of the cordless device to be paired is at least partially charged.
2. Press and hold down the pairing button on the back of the Cordless Module for 5
seconds to activate telephone pairing mode. The LED on the Cordless Module blinks.
The Cordless Devices application opens on the telephone and prompts you to "Press the
pairing button on the cordless device now."
3. Press and hold down the hookswitch on the cordless handset or headset for 5 seconds to
activate accessory pairing mode. The LED on the cordless accessory blinks. After a
moment, the Cordless Devices application displays protocol, firmware, hardware, and
IPEI information for the device to be paired.
Note: If the LED on the Cordless accessory does not start to blink after 10 seconds,
the accessory requires charging or is still in factory battery saving mode (handset
only). Place the accessory on the charger and charge. The green LED starts to flash
- 80 -