Cordless Headset Leds; Using The Cordless Devices Application - Mitel 5360 User Manual

Cordless Devices

Cordless Headset LEDs

There are two LEDs associated with the cordless headset:
•
•
The handset is blinking, when the LED is on and off for an equal amount of time. The handset is
winking, when the LED is on for a short period of time and off for a longer period of time.
Blue (on
headset)
Green (on
cradle)

Using the Cordless Devices Application

The Cordless Devices Application provides access to module information and pairing for
handset or headsets.
To access the Cordless Devices Application, do one of the following:
•
•
For information about programming feature keys, see
NOTE
Viewing Cordless Module Information
You can use the Cordless Module Application to view protocol, firmware, and hardware
information about the module.
To view cordless module information:
1.
2.
3.
Page 76
Blue – Indicates the operational status of the headset
Green – Indicates the status of the electrical charge of the battery
Led Color LED State
Solid
Blinking
Winking
Solid for 2 seconds
Solid
Blinking
Winking
Off
Press (Applications), and then press Cordless Devices.
Press a feature button (key) you have programmed as the Cordless Devices Application
key.
When the pairing button on the Cordless Module is pressed, or when the battery
level of a cordless accessory is critically low, the IP phone will automatically open
the Cordless Devices Application.
Press (Applications), and then press Cordless Devices.
Press Cordless Module Info. Device information appears on the screen.
Press Close to exit.
Indicates
Headset microphone is muted.
Headset is in pairing mode.
Active audio path between Headset and
Module.
Indicates one of the following:
•
Pairing successful
•
New battery installed
Battery is fully charged.
Battery is charging.
Indicates low voltage when headset is
uncradled.
When headset is cradled, indicates battery is
not charging.
page 27.
Mitel ® 5360 IP Phone User Guide – Issue 1, June 2010