Tag Call; Trunk Flash - Mitel MiVoice 5360 User Manual

An alternate speed dial number is supported for each contact, and the button label will show the
alternate number instead of the primary number for some presence states.
For the 5360, when a user presses a programmable key which is in the alternate speed dial
number state:

The programmable key text will change to display the primary number for two seconds giving
you the option to dial the primary number

If you press the button again while the primary number is displayed, the primary number will
be dialed; otherwise, the alternate number will be automatically dialed after the two second
timeout.

Tag Call

Tag Call allows you to signal that you are the victim of a threatening or malicious call. Using the
tag, your system administrator or Telephone Company can identify the source of the call and
provide this information to appropriate personnel or authorities.
CAUTION: Tagging a non-malicious call may result in fines or other penalties.
To tag a malicious call:
1. Press the programmed Tag Call key while the call is in progress. (For information on how to
program keys, see
-OR-
Press
2. Dial the appropriate feature access code.
If the call was successfully tagged, Thank You is shown on the display; otherwise, Not
Allowed is displayed.
Note: Tag Call can be used on active two-party calls only. Calls on hold and conference calls
cannot be tagged.

Trunk Flash

The Trunk Flash feature allows you to access Centrex features (if available) while you are talking
on an outside call.
To flash a trunk while talking on an outside call:
1. Press the key you have programmed to Flash.
Note: You can program a key to single flash or double flash.
2. Wait for dial tone.
3. Dial the Centrex feature access code.
Programing Features On Your
(TRANS/CONF).
MiVoice 5360 IP Phone User Guide
Keys.)
71