Protocol Settings - Benefon TRACK PRO 1.1 Owner's Manual

PROTOCOL SETTINGS

-
•Press to enter the
SELECT
tings menu. Scroll through the sub-menus
n
with .
.
•Press to cancel the operation and
QUIT
return to previous menu level.
A u t h o r i z a t i o n
In this menu you can select whether you
wish to receive protocol messages from
anyone or only from authorized num-
bers (authorized numbers are listed in the
Authorized numbers menu, for further infor-
mation, please see the previous chapter).
-
1. Press to enter the
CHANGE
tion menu.
2. Select the desired option by pressing
-
and .
OK
- If the authorization setting is En-
abled, only the authorized numbers
are valid senders of a protocol mes-
sage and the reply to the protocol
message will be sent back to the same
number.
142 MAIN MENU: SETTINGS
Protocol set-
3. To cancel the operation and return to
previous menu level, press
In this menu you can select, whether the
telematics protocol messages are put into
Authoriza-
storage, if e.g. there is no service at the mo-
ment. The storage capacity is 100 messages.
n
After the phone is in service again, these
messages are sent forward.
1. Press
storage
2. Select the desired option by pressing
and
- If the setting is Disabled, the sender
of a protocol message can be anyone,
e.g. the message can be sent from the
Internet or the number can be blank.
If the service center number is set, re-
ply is always sent to the service cen-
ter. If the service center number is
not set, reply is sent to the sender of
a protocol message (assuming the
sender´s number is available).
M e s s a g e s t o r a g e
-
to enter the
CHANGE
menu.
-
.
OK
.
.
QUIT
Message
n