Adjusting The Dp Leading Edge Registration - Kyocera Mita DP-100 Service Manual

3HK

(2) Adjusting the DP leading edge registration

Perform the following adjustment if there is a regular error between the leading edge of the original and the copy image.
U034
(See the service manual
of the copier.)
Caution:
Before making the following adjustment, ensure that the above adjustments have been made in maintenance mode.
Procedure
Enter maintenance mode.
Enter "071" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key.
Select "Exp. 1" (DP leading edge
registration) using the copy
exposure adjustment keys.
Press the program key and the
machine enters the test copy mode.
Place an original on the
DF and make a test copy.
Is the image correct?
Press the stop/clear key
to exit maintenance mode.
1-4-8
U066
(See the service manual
of the copier.)
Start
No
Yes
End
U071
Original
example 1
Figure 1-4-8
Press the start key.
The new setting is stored.
• For copy example 1,
decrease the value using
the zoom (-) key.
• For copy example 2,
increase the value using
the zoom (+) key.
Setting range: –32 – +32
Initial setting: 0
Changing the value by 1 moves
the copy image by 0.254 mm.
Copy Copy
example 2