Kyocera Mita DP-100 Service Manual page 26

3HK
• Detaching the DP forwarding pulley
3. Remove the stopper ring.
4. Pull out the forwarding shaft and then remove
the DP forwarding pulley.
• Detaching the DP feed pulley
5. Remove the two stopper rings.
6. Pull out the feed shaft and then remove the
DP feed pulley.
7. Clean or replace the DP forwarding pulley
and DP feed pulley.
8. Refit all the removed parts.
1-4-4
Spring collar S
DP feed pulley
One-way clutch 6
Feed gear 18
Pin
Feed shaft
Forwarding joint gear
Forwarding gear 18
Figure 1-4-3
Stopper ring
Stopper ring
Pin
DP forwarding pulley
holder
Stopper ring
Forwarding shaft
DP forwarding pulley