Mechanical Construction; Original Feed Section - Kyocera Mita DP-100 Service Manual

2-1-1 Mechanical construction

(1) Original feed section

The DP consists of the components shown in Figure 2-1-1. An original placed on the original table is conveyed the
original across the DP contact glass in synchronization with the copier scanning operation.
When a primary original feed starts, the original feed motor (OFM) is turned on in the forward direction, the DP
forwarding pulley rotates to forward an original, and then the DP feed pulley advances original feed. When the leading
edge of the original reaches the position that causes the DP timing switch (DPTSW) to be turned on, the primary feed
finishes. When the secondary original feed starts, the original feed motor (OFM) is turned on in the reverse direction, and
the original is conveyed onto the DP contact glass by rotation of the original feed motor and then ejected to the original
eject cover by the DP eject roller.
@
5
1 DP Forwarding pulley
2 DP feed pulley
3 DP eject roller
4 DP conveying roller
5 DP conveying pulley
6 DP conveying pulley
7 DP eject pulley
8 Paper feed housing
9 Eject guide
!
$ 2
#
&
4
6
9
0
Figure 2-1-1 Original feed section
1
8
3
7
*
%
0 Scanning guide
! DP Forwarding pulley holder
@ DP original cover
# Paper feed guide
$ Pad
% DP base
^ Original table
& DP timing switch (DPTSW)
* DP original detection switch (DPODSW)
^
2-1-1
3HK