Adjusting The Dp Trailing Edge Registration - Kyocera Mita DP-100 Service Manual

(3) Adjusting the DP trailing edge registration

Perform the following adjustment if the original scanning end position is not correct when the DP is used.
Caution:
If the copy image looks like copy example 2, clean the DP original scanning section.
Procedure
Enter maintenance mode.
Enter "071" using the copy exposure
adjustment keys or zoom +/- keys.
Press the start key
Select "Exp. 2" (DP trailing edge
registration) using the copy
exposure adjustment keys.
Press the program key and the
machine enters the test copy mode.
Place an original on the DP
and make a test copy.
Is the image correct?
Yes
Press the stop/reset key
to exit maintenance mode..
Start
• For copy example 1,
No
decrease the value using
the zoom (-) key.
• For copy example 2,
increase the value using
the zoom (+) key.
Setting range: –42 – +32
Initial setting: 0
Changing the value by 1 moves
the copy image by 0.254 mm.
End
Original Copy
example 1
Figure 1-4-9
Press the start key.
The new setting is stored.
3HK
Copy
example 2
1-4-9