Mechanical Problems - Kyocera Mita DP-100 Service Manual

1-3-4 Mechanical problems

Problem
(1)
No primary original
feed.
(2)
No secondary original
feed.
(3)
Originals jam.
Causes/check procedures
The surfaces of the DP forwarding pulley,
DP feed pulley or pad are dirty with paper
powder.
Check if the DP forwarding pulley, DP origi-
nal feed pulley or the pad is deformed.
Electrical problem with the original feed mo-
tor.
The DP conveying roller and the DP convey-
ing pulley do not contact each other cor-
rectly.
Electrical problem with the original feed mo-
tor.
Originals outside the specifications are used.
The surfaces of the DP forwarding pulleys,
DP feed pulley or pad are dirty with paper
powder.
The DP conveying roller and DP conveying
pulley or eject roller and eject pulley do not
contact each other correctly.
Corrective measures
Check and clean them with isopropyl alco-
hol if they are dirty.
If so, replace (see page 1-4-3).
See page 1-3-6.
Check visually and remedy if necessary.
See page 1-3-6.
Use only originals conforming to the speci-
fications.
Check and clean them with isopropyl alco-
hol if they are dirty.
Check visually and remedy if necessary.
3HK
1-3-7