Agilent Technologies E5071C ENA Service Manual page 309

34 User characterization not found in module
This error occurs when the selected user profile is not detected in the ECal memory, while
reading it from the ECal module, written by the user definition ECal.
V
30 Valid Ecal module not found
This error occurs when the number of ports of the ECal module connected is less than the
necessary number of ports. This error occurs, for example, when a 4-port Cal executing
command, SENS:CORR:COLL:ECAL:SOLT4, is executed with a 2-port ECal module
connected. This error is not generated by front key operations.
71 Valid power meter not found
Valid power meter is not connected.
This error occurs when the E5071C and the power meter is not connected with USB/GPIB
interface, the GPIB addresses do not match between the power meter and the E5071C's
power meter, or the power meter is turned off, during the measurement for power
calibration data or for that in scalar-mixer calibration.
It also occurs when inoperable power meter is connected.
Ensure the connection of the power meter, GPIB addresses and power supply.
72 Valid power sensor not found. No valid sensor is connected to the power
meter
This error occurs when no power sensor is connected to the specified channel of the power
meter, during the measurement for power calibration data or for that in scalar-mixer
calibration.
Ensure the connection of the power sensor.
75 Valid signal generator not found. No valid external signal source is
connected
This error occurs when the specified type of external signal source is not connected to the
specified GPIB address, though the control of the external signal source is enabled
(SENS:OFFS:LOC:STAT ON and SENS:OFFS:LOC:CONT ON).
It also occurs when USB/GPIB interface is set but not connected.
Ensure the external signal source and the connection of USB/GPIB interface.
Appendix E
User characterization not found in module
Messages
309