Belt Tension Adjustment Of The Scan Motor - Toshiba e-STUDIO2330C Service Handbook

3.7.2

Belt tension adjustment of the Scan motor

(1) Hook the belt tension jig to the motor bracket
and the flame.
(2) Loosen screw-B and -C. (There is no need to
loosen screw-A, since it is a shoulder screw.)
(3) The scan motor is pulled by the belt tension
jig. Fix screw-B and then -C at the stopped
position.
(4) Remove the belt tension jig.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ADJUSTMENT
Pulley
Timing belt
Belt tension jig
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
3 - 66
Belt tension jig
C
A B
Scan motor
Fig. 3-26
Fig. 3-27