Toshiba e-STUDIO2330C Service Handbook page 354

[CC31] Transport motor abnormality
* You receive a [CC31] error when the [ED12] error occurs three times in succession.
MJ-1101
Is there any mechanical problem when the stack transport roller -1 and -2 are rotated?
YES
NO
Is the harness between the transport motor (M2) and the finisher control PC board (CN5)
disconnected or open circuited?
l YES
NO
1. Replace the transport motor (M2).
2. Replace the finisher control PC board.
[CC40] Swing motor abnormality
MJ-1030
Is the swing unit home position sensor (PI35) normal?
NO
YES
Is the wiring between the finisher controller PC board and the swing motor (M36) correct?
NO
YES
Is the swing mechanism normal?
NO
YES
1. Replace the swing motor.
2. Replace the finisher controller PC board.
[CC41] Paper holder cam home position abnormality
MJ-1101
Is there any mechanical problem when the paper holder cam is rotated?
YES
NO
Is the harness between the paper holder home position sensor (S6) and the finisher control PC
board (CN17) disconnected or open circuited?
l YES
NO
1. Replace the paper holder home position sensor (S6).
2. Replace the finisher control PC board.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
Fix the mechanism.
• Reconnect the connector securely.
• Replace the harness.
Replace the sensor.
Correct the wiring.
Fix the mechanism.
Fix the mechanism.
• Reconnect the connector securely.
• Replace the harness.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
6 - 78