Toshiba e-STUDIO2330C Service Handbook page 323

Multifunctional digital color systems

Hide thumbs Also See for e-STUDIO2330C:

Table of Contents

[EAC0] Transport delay jam

1. Check if there is any paper in the finisher, saddle stitcher or the on the transport path of the

equipment. Remove it if there is.

2. Is the connector J708 on finisher controller PC board disconnected?

3. Is the harness between the finisher controller PC board and inlet sensor [PI33] open circuited?

4. Is the inlet sensor working properly? (Check the movement of the actuator.)

5. Replace the sensor.

6. Replace the finisher controller PC board.

e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C

ERROR CODE AND TROUBLESHOOTING

Show Quick Links

Table of Contents