Toshiba e-STUDIO2330C Service Handbook page 423

[I] Set EFI Printer Board
If the EFI Printer Board (GA-1211) is installed, perform the following procedure.
(1) Turn the power OFF.
(2) Start the setting mode (08).
(3) Initialize the EFI Printer Board (08-700).
(4) Turn the power OFF.
[J] Reinstall options
When any of the options below was installed, reinstall a license for the corresponding option following
its unpacking instructions.
• Meta Scan Enabler (GS-1010)
• External Interface Enabler (GS-1020)
• Data Overwrite Enabler (GP-1070)
• IPSec Enabler (GP-1080)
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
7 - 27
REPLACEMENT OF PC BOARDS/HDD
7