Toshiba e-STUDIO2330C Service Handbook page 357

[CC61] Punch motor (M3) home position detection error
* The [CC61] error will be displays when the [E9F0] error occurs three times in succession or
during the initial operation.
MJ-1101 (When MJ-6101 is installed)
Is there any paper remaining on the transport path?
YES Remove the paper.
NO
Rotate the punch motor (M3). Does it rotate smoothly?
NO Fix the mechanism.
YES
Are the punch home position sensor (S4) and its wiring correct?
NO Replace the sensor. Correct the wiring.
YES
Is the wiring between the hole punch control PC board (HP) and punch motor (M3) correct?
NO Correct the wiring.
YES
1. Replace the punch motor (M3).
2. Replace the hole punch control PC board (HP).
[CC71] Punch ROM checksum error
MJ-1101 (When MJ-6101 is installed)
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short
circuited?
YES Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.
[CC72] Punch RAM read/write error
MJ-1101 (When MJ-6101 is installed)
Is the conductor pattern on the hole punch control PC board (HP) open circuited or short
circuited?
YES Replace the hole punch control PC board (HP).
NO
Replace the finisher control PC board.
[CC80] Front jogging motor abnormality/Front aligning plate motor abnormality
MJ-1030 (Front aligning plate motor abnormality)
Is the front aligning plate home position sensor (PI36) normal?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the front aligning plate motor (M33)
correct?
NO Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
NO Fix the mechanism.
YES
1. Replace the front aligning plate motor.
2. Replace the finisher controller PC board.
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
ERROR CODE AND TROUBLESHOOTING
6 - 81
6