Toshiba e-STUDIO2330C Service Handbook page 446

Notes:
• The display of items on this screen varies depending on the types of data written on the USB
media. Each item is displayed only when each data file is written on the USB media in the
following conditions.
1. OS Update
2. HDD SYS Update
3. Engine Main Firmware Update
4. Scanner Firmware Update
5. MEP Firmware Update
• If the USB media are not recognized properly, "Set Correct USB Storage Device" message is
displayed. In this case, disconnect the USB media and connect again within 3 minutes, or
shut down the equipment and connect the device properly. Then repeat the procedure from
(4).
• If any of the error messages below is displayed, confirm if the update program or the data file
in the USB media is correct. Then repeat the procedure from (4).
Error
number
- There is no mentusb2.o
01 There is no dlFirmWare_2820C_3530C in the
storage device.
02 Error Loadmodule
03 Machine Model Get Error
04 Please Change USB Storage or Please Check
ROMDATA
05 Other models ROMDATA Vxxxx.xxx x
*
(5) Select "5. MEP Firmware Update" with the digital keys.
"*" is displayed next to the selected item. Display or delete the "*" by pressing the number of the
item.
5. MEP Firmware Update
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
FIRMWARE UPDATING
Item
For the details, see the following page:
Scanner ROM"
•
•
Error message
The version name comes at "xxxx.xxx.x".
Item
Fig. 8-2
Condition
P.8-7 "8.1.1 Master data/System ROM/Engine ROM/
The Imaging Acceleration Board (GE-1170, optional) must
be installed.
T450IWW.xxx is written.
* xxx is version.
Update program loader (mentusb2.o)
is not stored.
Model specific update program
(dlFirmWare_2820C_3530C ) is not
stored.
Module loading failed.
Model information was not
downloaded.
Checking of data file failed.
Master data of other model (hdd.bin)
are stored.
Updating the Imaging Acceleration Board ROM
© 2008, 2009 TOSHIBA TEC CORPORATION All rights reserved
8 - 18
Cause
Remarks