Configure Log; Test Connectivity - TRENDnet TEW-821DAP User Manual

TRENDnet User's Guide
 Disable sleep mode on your computer as this may interrupt the firmware upgrade
process.
 Do not upgrade the firmware using a wireless connection, only using a wired
network connection.
 Any interruptions during the firmware upgrade process may permanently damage
your router.
1. Log into your router management page (see "Access your router management page"
on page 22).
Note: You can check your router's current firmware version at the top right of the
page.
2. Click on Maintenance, and click on FW Upgrade.
Note: This page also displays the current firmware version of your router.
3. Depending on your web browser, next to Upgrade Firmware, click Browse or Choose
File.
4. Navigate to the folder on your computer where the unzipped firmware file (.bin) is
located and select it.
5. Click Upgrade to start the firmware upgrade process. If prompted, click yes or OK.

Configure log

Management > Log
1. Log into your management page (see
2. Click on the Management tab and click Log. Click apply to save settings
© Copyright 2015 TRENDnet. All Rights Reserved.
"Access the management page" on page 16).
 Enable System log: Select option to enable system log feature
 Syslog Server IP Address: Enter the IP address of the syslog server or select from
the pull down menu
 Local Log: Select enable to enable local log feature

Test connectivity

Management > Diagnostics
Ping Test
1. Log into your management page (see
2. Click on the Management tab and click Diagnostic.
 IP : Enter the IP address you would like to conduct the ping test
 Packet Length: Enter the packet size
 Number of Pings: Enter the amount of pings to conduct.
 Ping: Click to start ping test
TraceRoute
1. Log into your management page (see
2. Click on the Management tab and click Diagnostic.
TEW-821DAP
"Access the management page" on page 16).
"Access the management page" on page 16).
32