Table of Contents
Advertisement
3-2-5. Connecting Ethernet Interface Cable
To protect the unit from electromagnetic interference, affix the two supplied ferrite cores to the
printer and router (hub) sides of the cable, respectively. Follow the instructions given below.
Option: LAN CABLE 1.0 M TSP1E
(1) Make sure the printer is turned off.
(2) Affix the ferrite core onto the Ethernet cable as
shown in the illustration below.
(3) Pass the fastener through the ferrite core.
(4) Loop the fastener around the cable and lock it.
Use scissors to cut off any excess.
Ferrite core
(5) Connect the Ethernet cable to the connector on
the rear panel of the printer.
Ethernet cable
Fastener
10 cm
(maximum)
– 10 –
Pull and cut
Advertisement
Table of Contents
