Slip Paper - Oki PH640 User Manual

5-2. Slip Paper

5-2-1. Specifications
(1) Width:
(2) Length:
(3) No. of copies:
(4) Total thickness:
(5) Copy slippage:
(6) Adhesive:
Note: Be particularly careful with paper that has adhesive on the left end because it might
feed diagonally.
Note:
1) Do not use paper that is curled, kinked, wrinkled, warped, or torn.
2) Do not use paper that has holes in the positions shown below, and do not print on the
back of paper that has low reflectance, because it can cause the paper sensor to
operate improperly.
3) The copying performance of the printer is greatly affected by the ambient temperature.
Therefore, print under the conditions described below.
Number of copies
Original + 3 copies
Original + 1 copy
68 ~ 230 mm
75 ~ 297 mm
original + 3 copies
1 sheet 0.09 ~ 0.15 mm (up to A4 portrait)
0.09 ~ 0.20 mm (up to A6 portrait)
4 sheets 0.09 ~ 0.31 mm
1.5 mm or less per 15 lines (between original and bottom-
most paper)
top-bound = good
right-bound = acceptable;
left-bound = acceptable
bottom-bound = unacceptable
Ambient temperature
10 ~ 40°C (50 ~ 104°F)
5 ~ 45°C (41 ~ 113°F)
– 26 –
37 mm
27 mm
8 mm
: Holes not allowed
: Printing not allowed on pa-
per with holes or reflectance
below 40%