Dürkopp Adler 967 Service Instructions Manual page 79

Adjusting the thread cut-off
Figure 52: Basic setting of the thread cutter
(1) - Roller
(2) - Gage
(3) - Upper lever
(4) - Control cam
(5) - Base plate
(6) - Stop lever
(7) - Screws
Setting steps
1. Undo the screws (7) of the stop lever (6) and the screws (9) of the
2. Secure the screws (11) for the lower lever (12) to the flat on the lower
3. Put the handwheel into the 80° position  page 20.
4. Lightly tighten the screws (7) of the stop lever (6), to that the stop lever
5. Insert a 0.1 mm feeler gage (2) between the control cam (4) and roller (1).
6. Press the upper lever (3) down and at the same time turn the stop
7. Tighten both screws of the eccentric lever (7).
8. Check the distance between the roller (1) and control cam (4), and adjust
9. Turn the piston (8) until it is just short of the stop (approx. 0.5 mm dis-
10.Tighten the screws (9) for the lever (10).
Service instructions 967 - 00.0 - 12/2014
lever (10).
shaft (13) and tighten both screws.
(7) can be turned on the lower shaft (13) with a slight frictional torque.
lever (6) until it contacts the baseplate (5).
it if necessary.
tance).
(8) - Piston
(9) - Screws
(10) - Lever
(11) - Screws
(12) - Lower lever
(13) - Lower shaft
77