Table of Contents
Advertisement
Double click the Add New Hardware icon.
2.
Press the Next button to begin installing the hardware.
3.
Press Next again to allow Windows to automatically
detect the new hardware. Press Next a third time to be-
gin the detection process.
4.
Once detection is complete, press the Finish button. Both
the serial mouse and the NEC VersaGlide touchpad will
function.
If you remove the serial mouse and restart your system,
the mouse icon appears in the device manager list with a
circled exclamation point over it. This indicates that the
mouse is not available.
MS-DOS Mode
To use the serial mouse in MS-DOS mode for Windows 95
systems, you must modify the MS-DOS start file. Modify-
ing this file disables the VersaGlide touchpad in MS-DOS
mode. (It is still available in Windows.) Therefore, to access
VersaGlide functions in MS-DOS mode, you must change
your system start file back to its original form.
Follow these instructions to use a serial mouse in MS-DOS
mode.
With system power turned off, connect the serial mouse
1.
to the COM port and power on your system.
From the Windows 95 Start menu, select Programs and
2.
the MS-DOS Prompt to open the MS-DOS window.
At the C:\WINDOWS> prompt, type the following
3.
command and press
Locate the following line in the dosstart file:
4.
.
Enter
edit dosstart.bat
C:\SYNTOUCH\SYNTOUCH
Using Your NEC Versa 4-35
Advertisement
Table of Contents
