Completing The Move; Fitting The Stability Bracket And Chain - Falcon Classic Deluxe User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have nished.
Fig.7-5
Fig.7-6
ArtNo.010-0004 Moving the cooker
Stability bracket
Fig.7-7
3 mm min
ArtNo.070-0014 - Stability bracket - Wall fitting
Typical oor mounting
Fig.7-8
Outer stability
bracket
3 mm min
Wall
Typical wall mounting
Fig.7-9
Restraining
chain
ArtNo.011-0007 - Restraining chain (AUS)
INSTALLATION
Lowering the Two Rear Rollers
To adjust the height of the rear of the cooker, rst t a 13
mm spanner or socket wrench onto the hexagonal adjusting
nut (Fig.7-5). Rotate the nut – clockwise to raise – counter-
clockwise to lower.
Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.

Completing the Move

Unfold the rear edge of the cardboard base tray. Open the
grill door and right-hand oven door so that you can get a
good grip on the bottom of the fascia panel as you move the
oven (Fig.7-6).
Carefully push the cooker backwards o the cardboard base.
Remove the base tray.
Position the cooker close to its nal position, leaving just
enough space to get behind it.
n

Fitting the Stability Bracket and Chain

n
Cooker
Unless properly installed, the cooker could be tipped by
leaning on the door. Injury might result from spilled hot
liquids or from the cooker itself.
IMPORTANT: The cooker must be set to the correct height
and levelled before the stability bracket is installed.
Floor
Fitting a Stability Bracket
When tting a stability bracket please refer to the instructions
supplied with the bracket for further details on tting.
When tting a stability bracket (Fig.7-7 and Fig.7-8) adjust
the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
Cooker
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Fitting the Restraining Chain
Floor
The restraining chain MUST be tted.
The length of chain between the appliance and the wall xing
should prevent strain on the gas and electricity connections,
but still allow access to unhook the chain when the cooker is
pull forward.
Measure the length of chain required. Use the clamp supplied
to clamp onto the gas pipe (Fig.7-9). Fix the supplied hook
securely to the wall.
24
DO NOT use the door handles or control knobs to
n
manoeuvre the cooker.
A stability bracket and chain MUST be tted when
n
the cooker is connected to a exible gas supply.