Yamaha MT07A Owner's Manual page 88

PERIODIC MAINTENANCE AND ADJUSTMENT
3
2
1. Front wheel axle pinch bolt
2. Wheel axle
3. Brake caliper bolt
6
2. Lift the front wheel off the ground
according to the procedure in the
previous section "Supporting the
motorcycle".
3. Remove the brake hose holder on
the left side by removing the bolt.
4
1
1. Brake hose holder
2. Bolt
3. Brake caliper
4. Brake caliper bolt
4. Remove the brake caliper on each
side by removing the bolts.
NOTICE: Do not apply the brake
after the brake calipers have
been removed, otherwise the
brake pads will be forced shut.
[ECA11052]
5. Pull the wheel axle out, and then
remove the wheel.
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle from the right
side.
3. Lower the front wheel so that it is
1
4. Install the brake calipers by install-
2
TIP
Make sure that there is enough space
between the brake pads before install-
3
ing the brake calipers onto the brake
discs.
5. Install the brake hose holder by in-
6. Tighten the brake caliper bolts and
7. Tighten the wheel axle, and then
6-38
on the ground, and then put the
sidestand down.
ing the bolts.
stalling the bolt.
the brake hose holder bolt to the
specified torques.
Tightening torques:
Brake caliper bolt:
40 Nm (4.0 m·kgf, 29 ft·lbf)
Brake hose holder bolt:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
the wheel axle pinch bolt to the
specified torques.