Yamaha MT07A Owner's Manual page 63

2
1. Radiator cap
2. Radiator cap retaining bolt
4. Remove the coolant reservoir cov-
er by removing the bolt and quick
fastener, and then remove the
coolant reservoir.
2
1
3
1. Coolant reservoir cover
2. Bolt
3. Quick fastener
PERIODIC MAINTENANCE AND ADJUSTMENT
5. Remove the coolant reservoir cap.
1
1
2
1. Coolant reservoir cap
2. Coolant reservoir
6. Drain the coolant from the coolant
reservoir by turning it upside
down.
7. Install the coolant reservoir and its
cover by placing them in the origi-
nal position, and then installing the
bolt and quick fastener.
8. Remove the coolant drain bolt and
1. Coolant drain bolt
2. Gasket
9. After the coolant is completely
10. Install the coolant drain bolt and
11. Pour the specified amount of the
6-13
its gasket to drain the coolant from
the cooling system.
drained, thoroughly flush the cool-
ing system with clean tap water.
its new gasket, and then tighten
the bolt to the specified torque.
Tightening torque:
Coolant drain bolt:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
recommended coolant into the ra-
diator and reservoir.
2
1
6