Yamaha MT07A Owner's Manual page 27

If a problem is detected in the immobi-
lizer system circuits, the immobilizer
system indicator light will flash and the
display will indicate an error code.
TIP
If the display indicates error code 52,
this could be caused by transponder
interference. If this error code appears,
try the following.
1. Use the code re-registering key to
start the engine.
TIP
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off and
try starting the engine with the
standard keys.
3. If one or both of the standard keys
do not start the engine, take the
vehicle, the code re-registering
INSTRUMENT AND CONTROL FUNCTIONS
key and both standard keys to a
Yamaha dealer and have the stan-
dard keys re-registered.
NOTICE
If the display indicates an error
code, the vehicle should be checked
as soon as possible in order to avoid
engine damage.
Brightness control mode
1
1. Brightness level display
The brightness of the multi-function
meter unit panel can be adjusted to
suit the rider's preference.
To adjust the brightness
1. Turn the key to "OFF".
2. Push and hold the left set button.
3-12
3. Turn the key to "ON" and continue
pushing the left set button until the
display switches to the brightness
ECA11591 control mode.
4. Push the right set button to set the
brightness level.
5. Push the left set button to confirm
the selected brightness level and
exit the brightness control mode.
3