Helmet Holding Cable - Yamaha MT07A Owner's Manual

2
1. Passenger seat
2. Hexagon wrench
2. Pull up the corners on the rear of
the rider seat as shown and re-
move the bolts with the hexagon
wrench.
1. Bolt
3. Lift the seat rearward and up to re-
move it.
INSTRUMENT AND CONTROL FUNCTIONS
To install the rider seat
1. Fit the slot in the seat onto the pro-
jection on the frame cross mem-
1
ber as shown, and then place the
seat in the original position.
2
1. Slot
2. Projection
1
2. Install the bolts with the hexagon
wrench.
3. Insert the hexagon wrench back
into its holder on the passenger
seat.
4. Install the passenger seat.
TIP
Make sure that the seats are properly
secured before riding.

Helmet holding cable

A helmet holding cable is located on
the bottom of the passenger seat. Use
this cable in conjunction with the
screwdriver to secure a helmet to the
vehicle.
1
1. Passenger seat
2. Helmet holding cable
3. Screwdriver
To secure a helmet with the helmet
holding cable
1. Remove the passenger seat. (See
2. Remove the screwdriver from its
3-20
2
1
3
page 3-19.)
holders on the passenger seat,
and then remove the helmet hold-
ing cable from the screwdriver.
EAU59981
3