Alignment; Tools Needed; Remove Foam Motor Support; Checking Table Insert - RIDGID TS2400 Owner's Manual

Alignment

Tools Needed

Phillips Screwdriver
Combination Wrenches
3/8, 7/16 In. 1/2 In. 9/16 In.

Remove Foam Motor Support

A block of foam was placed under the motor at the
factory for shipping. Lift up one edge of the saw
base and remove the foam.

Checking Table Insert

WARNING: To reduce the risk of injury from acci-
dental start, make sure switch is "OFF" and plug is
not connected to power source outlet.
1. Insert should be flush with table top. Check as shown.
Loosen flat head screw that holds insert and adjust the
four set screws as necessary. Tighten flat head screw.
Do not tighten screw to the point where it bends the
insert.
CAUTION: Insert must be even with the table sur-
face. Inserts too high or low can let the workpiece
"snag" or catch on uneven edges. Workpiece
could twist and kickback.
2. To remove insert.
a. Make sure saw is off and unplugged.
b. Loosen flat head screw.
c. Lift insert from front end, and pull toward front of saw.
3. To replace insert.
a. Make sure saw is off and unplugged.
b. Place insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert will drop over flat head screw.
Tighten screw.
c. Do not tighten screw to the point where it bends the
insert.
Hex "L" Wrenches
3/32 In., 5/32 In., 3/16 In.
Combination
Square
15
Combination Square must be true. Check it's
accuracy as shown below.
Select the straight edge of
Draw light line on
3/4" thick board. This edge
board along edge
must be perfectly straight.
NOTE: The square and
straight edge are used to
align the saw. They must
be accurate if the saw is
to be aligned properly.
Should be no gap or overlap here when square
is flipped over in dotted position.
Table Insert
3/32 In.
Hex "L" Wrench
Flat Head
Screw