Mounting Your Saw
Mounting Table Saw to RIDGID Universal
Power Tool Legset #AC9910
1. Assemble legset per instructions.
2. Locate the four (4) "TS" layout points on the particle
board tables.
3. Drill the four (4) above holes.
4. Insert four (4) 1/4-20 screws that are long enough for
washers and nuts which will properly secure the table
saw to the legset. Tighten hardware.
NOTE: Mounting hardware (bolts, nuts, washers, etc.)
are not supplied with the saw.
Workbench Mounting Using "C" Clamps
An alternative method of securing your table saw is to
fasten the saw base with "C" clamps.
1. Follow instructions for mounting to workbench, substi-
tute "C" clamps at each mounting screw location.
2. Securely clamp saw to workbench using four "C"
clamps, as shown.
Supporting surface where saw is to be mounted should
be examined carefully after mounting to insure that no
movement can occur during use. If any tipping, sliding or
walking is noted, secure the workbench or cabinet before
operating the table saw.
Supporting Table Saw with Sawhorses
The table saw has provisions for being supported by saw-
horses. The sawhorse can be built with the 2" x 4"cross-
pieces either vertical or horizontal. Make sure the
sawhorses are secure. Holes for securing unit to saw-
horse(s) are provided.
"C" Clamps
(Front and Rear)
Diagram of Clamping Table Saw to Workbench
26
Mounting
Screw Location
"C" Clamp