Assembling Herc-U-Lift™ Caster System To Saw; Installation Instructions - RIDGID TS3612 Owner's Manual

Assembly (continued)
Assembling Herc-U-Lift™ Caster
System to Saw

Installation Instructions

WARNING: To reduce the risk of
injury from unexpected starting,
unplug the tool before attaching
caster set.
1. From the bag of loose parts remove the
following hardware:
*4 Hex Head Screw w/Washer 1/4-20 x
1-5/8
*4 Washer 1/4 I.D.
*12 Lock Nut 1/4-20
*8 Hex Head Screw 1/4-20 x 1/2
2. From the bag of loose parts remove the
following:
4 Leg Bracket
3. Install the four leg brackets on the
inside of each leg using 1/4-20 x 1/2"
hex head screws and lock nuts. Tighten
screws securely.
4. Place the Lower Assembly under the
saw with the front ends of the tube
under the front leg brackets. Install the
hex head screw (1/4-20 x 1-5/8)
through the front leg bracket and tube
as shown. Install the washer and lock
nut and tighten the lock nuts until flush
with bottom of screw. The screw should
freely pivot side to side.
5. Place the upper assembly under the
saw (see illustration) with the rear ends
of the tube under the leg brackets and
install the hex head screw (1/4-20 x 1-
5/8), washer and nut in the same man-
ner as step 5. Center the upper tubes
between the lower tubes and tighten all
hardware at this time beginning with the
four (4) screws attaching the plate
assembly to the tubes.
6. Insure the upper tubes remain centered
between the lower tubes and tighten
the hardware on the lower assembly.
1/4-20 x 1-5/8
Hex Head Screw w/Washer
1/4-20 x 1/2
Screw Hex Hd.
Leg Bracket
Distance on Each Side
Adjust U-Bolt
Centered Within
Latch Mechanism
U-Bolt
7. Press down on the plate assembly and
check alignment of the U-bolt. The U-
bolt should be centered within the latch
mechanism as shown. Release pedal
and adjust the U-bolt as necessary,
then tighten the nuts holding the U-bolt
to the tube.
28
1/4 I.D.
1/4-20
Washer
Lock Nut
Center Frames Equal
Tighten all Nuts
Latch
Mechanism