Table of Contents
Advertisement
CONFIGURING PTZ PRESET TOURS
The PTZ tab allows you to configure a PTZ camera to cycle through a series of
preset camera views. Up to six presets can be included in the tour; the presets are
configured on the PTZ Settings tab on the Monitor page.
To configure a PTZ tour, complete the following steps on the PTZ tab:
1.
Select a camera from the camera list.
2.
In the Pattern Setup area, create the tour in the list on the right side using
presets from the left side. To add a preset to the tour list, select the preset
in the left list and click Add. To remove a preset from the tour list, select
the preset in the right list and click Remove. To reorder a preset in the
tour list, select it and click Move Up or Move Down.
A preset can be included in the tour multiple times.
3.
Select a delay (from 3 to 60 seconds). This is the amount of time that the
camera pauses at each preset before proceeding to the next preset in the
tour.
To activate the tour, select the camera's video window on the Monitor page and
click Start Pattern on the PTZ Settings tab.
57
Advertisement
Table of Contents
