Switch - Joyner JNSZ1100SVB Owner's Manual

brake lever set. Indicator light will illuminate indicating park brake is engaged. (See
figure 2)
• Set park brakes: pull-up on the park brake lever until the lever is tight.
• Release park brakes: Pull-up on the park brake lever, depress the release button and
push the lever
5) Shift Selector: Changes trans-axle gears from neutral to forward or reverse. Always
start engine in neutral. (See figure 3)
• Pull up on shift selector collar and move lever to position "1" "2" "3" "4", the vehicle will
move forwards at different speed.
• Pull up on shift selector collar and move lever to center position to place trans-axle in
neutral.
• Pull up on shift selector collar and move lever to position "R", the vehicle will move
backwards.
Shift Selector
Park brake lever
FIGURE 2
FIGURE 3

Switch

6) Ignition Switch: Pull firmly up on the park brake lever with your hand until the lever
is tight. Set shift selector in neutral. Insert the key into key-switch, turn the key clockwise,
and release the key when the engine starts. (Warning: Don't crank starter more than 5
seconds at one time). (See figure 4)
7) Turning-light switch: control the turning- light. Press the top of button down and the
right turning light work; Press the bottom of button down and the left turning light work;
Set the button in neutral while moving in line. (See figure 5)
8) Head light switch: control the headlight far beam or lower beam. Press the
lower-beam button down and the head light work as lower beam, the far-beam button
and work as far beam. (See figure 5)
Head light switch
Turning-light switch
Ignition Switch
Spot light switch