Configuring Network Protocol Via The Machine - Muratec MFX-C4000 Field Engineering Manual

7.3.2 Configuring network protocol via the machine

You can setup TCP/IP Network parameters please follow the steps listed below.
1. Make sure your machine is connected to the network with an RJ-45 Ethernet cable.
2. Make sure you turned on the machine.
3. Press Machine Setup button on the control panel.
4. Press Admin Setting.
5. When the login message appears, enter password. Touch the password input area, then the question
marks appears. Use the number keypad on the control panel to enter the password. Once the password is
entered, press OK. (Factory setting:1111)
6. Press the Setup tab > Network Setup.
7. Select TCP/IP Protocol.
8. Press IP Setting.
Service Manual
Installation
7-33