Muratec MFX-C4000 Field Engineering Manual page 204

2) JAM 0
Description : Paper is jammed at Tray 1
Check where the jammed paper
is located.
Paper still inside the Tray ?
Pull out the tray and start the printing job with
Leg-M_Act No Paper on by lift upside.
Check if the MEA Unit -Roller PU is rolling or
not.
Does the MEA Unit -
Roller PU rotate?
Replace the MEA Unit -Cassette or the
MEA Unit-Roller PU.
End
Service Manual
Alignment & Troubleshooting
Leg-M_Act No Paper
Photo Interrupter
Clutch
HVPS
No
Yes
No
Yes
OK
MEA Unit-Roller PU
Leg-M_Act Ready DP
Motor DC-Main
MEA Unit-Cassette
Check if any object or obstruction is on
the path before the forward roller. If any,
remove it or them.
Check if the Photo Interrupter(Registration
Sensor) works or not
- You can make sure of it by actuating the
Leg-M_Act Ready DP. If it does not work,
replace the HVPS.
Check the Clutch and the Motor
DC-Main work or not. If needed,
replace them.
End
4-98
No
OK
End
End