Muratec MFX-C4000 Field Engineering Manual page 197

Problem Description
Continuous Logo
Display at Initial
State
No Response from
MCB
Service Manual
Alignment & Troubleshooting
Cause Description
1. Fail to Initialize
Communication Port
between Video PBA
& GUI
1. Disconnected
Communication
between Video PBA
& GUI
Action to Resolve
[1. Fail to Initialize Communication Port between Video PBA &
GUI]
1.1) Check the connection between Video PBA and GUI PBA.
1.2) Reboot the set.
1.3) Send any printing command.
1.4) If the printing job works, replace GUI PBA.
1.5) If the printing job does not work, replace Video PBA.
[1. Disconnected Communication between Video PBA & GUI]
1.1) Check the connection between Video PBA and GUI PBA.
1.2) Reboot the set.
1.3) If the set displayed the same error message, replace Video
PBA.
4-91