Unpacking And Assembling Epson Stylus Pro; 7880/7880C/7450 - Epson STYLUS PRO 7450 Unpacking & Setup Instructions

Unpacking and Assembling
EPSON Stylus Pro

7880/7880C/7450

Choosing a Place for the Printer
❏ Leave adequate room for easy operation,
maintenance, and ventilation as shown below.
(Values in the illustration below are the
minimum.)
❏ Leave at least 20 cm between the back of the
printer and the wall.
❏ Place the printer on a desk. If you cannot place
the printer on a desk, you will need the Stand.
If you place your printer on a desk, follow the
guidelines listed below.
❏ Choose a desk that can hold the printer
weight (about 49 kg) and has a height of
600-800 mm from the floor.
❏ Make sure the surface is flat and stable.
❏ Place the front rubber legs of the printer
just at the end of the desk.
❏ Leave enough room (over 600 mm) in
front of the desk.
❏ Prevent your printouts from getting dirty
or crinkled.
❏ Use a grounded power outlet. Do not use a
damaged or frayed power cord. Avoid using
an outlet that is shared with other appliances.
❏ Use only an outlet that meets the power
requirements of this printer.
❏ Operate the printer under the following
conditions:
Temperature: 10 to 35°C
Humidity: 20 to 80% without condensation
❏ Avoid locations that are subject to direct
sunlight, excessive heat, moisture, or dust.
❏ Do not block the ventilation openings.
❏ Avoid locations near potential sources of
interference such as loud speakers or cordless
phones.
❏ Avoid locations near TVs, radios, air
conditioners, or humidifiers.
❏ Avoid locations that are subject to shocks or
vibrations.
❏ Keep the printer away from combustible
substances.
❏ Keep the printer away from dusty areas.
Deciding Where to Unpack the Printer
Before unpacking, read the followings:
❏ Setup and assemble the printer near to the
chosen place of use, as moving the printer may
result in damage.
❏ Allow floor space of 2.5 × 2.5 m approx., and
height of at least two times that of the larger
box containing the printer unit.
11