Setting Up The Printer; Connecting The Power Cord - Epson STYLUS PRO 7450 Unpacking & Setup Instructions

4. Set 2 paper guides at the bottom of the printer
as shown below, when you feed the paper
forward or backward.
After attaching the paper guides, be sure to fix
them in the forward position.
Reusing the Packaging
If you need to transport your printer a long
distance, the printer should be repacked using the
original boxes and packing materials. Contact
your dealer for assistance.
16

Setting up the Printer

Connecting the Power Cord

Note:
Most illustrations shown in this section are for EPSON
Stylus Pro 9880/9880C/9450, so they may vary in
appearance from EPSON Stylus Pro
7880/7880C/7450. The instructions are the same,
except as noted.
1. Check the label on the back of the printer to
make sure the voltage required by the printer
matches that of the wall outlet. Also, make
sure that you have the correct power cord for
your power source.
c Caution:
It is not possible to change the printer's
voltage. If the rated voltage and your outlet
voltage do not match, do not plug in the
power cord, and contact your dealer for
assistance.
2. Connect the power cord to the AC inlet on the
back of the printer.