Epson STYLUS PRO 7450 Unpacking & Setup Instructions page 9

Note:
When you place the printer on the base unit, match
the right end square of the printer (shown as 4 in
the illustration below) to the square of the same part
of the base unit.
top view
4. Fasten the bottom of the printer and base unit
with wing nut, spring washers, and washers
(H).
H
5. Release the front casters and the stabilizer
knobs and move the printer to the place of use
(a short distance away). Lock the casters and
extend the stabilizer knobs after moving.
6. Remove the protective tapes.
a
b
a: from the front cover
b: from the ink compartment cover
C: from the maintenance tank
7. Open the front cover. Remove the protective
screw (L) and metal plate (M) from the side of
the print head compartment. (Follow the red
wire (N) fixed on the cover of the printer and
you can see the screw at the edge of the wire.)
C
7