Connecting The Printer With Your Computer; Installing The Printer Driver And Software - Epson STYLUS PRO 7450 Unpacking & Setup Instructions

Connecting the Printer with Your
Computer
Connect the printer and computer with a USB
cable or Ethernet cable. Use the following cables.
❏ USB cable
❏ 10BaseT or 100BaseTX Category 5 Shielded
twisted-pair cable
1. Make sure the printer is turned off.
2. Connect the cable to the printer, and plug the
other end of the USB cable to the computer or
the other end of the Ethernet cable to the
Ethernet hub.
USB connection:
Network connection:
Note:
When you connect both USB cable and Ethernet cable,
install the printer software from each computer
separately. You can connect both USB cable and
Ethernet cable to the printer at the same time.
24
Installing the Printer Driver and
Software
After connecting the printer to your computer,
you need to install the software included on the
Printer Software CD-ROM shipped with your
printer. To install your printer software, follow the
steps below.
Note:
Be sure that you have an administrator rights to install
the software.
1. Insert the Printer Software CD-ROM shipped
with your printer in the CD-ROM drive.
2. When the following dialog box appears,
install the printer driver according to your
connection. Select Set up the printer via a
local connection when the printer is
connected to the computer directly or Set up
the printer via a network connection when
the printer is connected to the network. Follow
the on-screen instructions.