Table of Contents
Advertisement
❏ ❏
5. Inside of the servo bay you will fi nd a string taped.
Pull the string out and tie the string to the servo extension
connector. Locate the hole in the top center of the wing.
Carefully pull the string with the lead attached to it through
the wing. Tape the servo lead to the wing to prevent it from
falling back into the wing. Important! The string is a single
string that extends to both of the servo openings. Be careful
not to pull the string loose from the other servo opening.
❏ ❏
6. Secure the servo cover with four #2 x 5/16" [8mm]
washer head screws. Before installing the cover, insert and
then remove a screw into the mounting holes in the servo bay.
Apply a drop of thin CA glue to harden the threads. After the
glue hardens install the servo cover.
❏ ❏
7. Install the z-bend end of a 5/64" x 6" [2mm x 152mm]
aileron pushrod wire into the hole you drilled in the nylon
servo arm.
❏ ❏
8. Locate a black control horn. Important! The hardware
includes two different style horns. Be sure you use the horn
pictured here. Glue it into the slot in the aileron.
❏ ❏
9. Locate the aluminum screw-lock connector, black
nylon retainer and the 2-56 x 3/16" [4.8mm] set screw. Test
fi t the screw lock connector into the outer most hole in the
aileron control horn. If it is too tight, enlarge the hole slightly
with the blade of a hobby knife. Be sure not to make the hole
too large. Remove the screw-lock connector from the control
horn. Slide the aluminum screw-lock connector onto the aileron
7
Advertisement
Table of Contents
