GREAT PLANES Super Stearman Instruction Manual page 15

❏
4. Two lengths of Velcro
the battery. If you are using the recomended battery you will
only need to install Velcro
and shaped batteries may require the use of the second piece.
®
Install the Velcro as needed.
❏
5. Center the servo and then install a screw lock connector,
nylon retainer and 2-56 x 3/16" [2mmx 4.8mm] screw into the
center hole on the servo arm.
❏
6. Install the elevator servo into the servo tray, sliding
the pushrod wire into the screw lock connector. Drill a 1/16"
[1.6mm] hole through each of the servo mounting tab holes.
Install and remove the servo mounting screw. Apply a couple
drops of thin CA in the screw hole to harden the threads. Once
the glue has hardened, secure the servo with the mounting
screws that came with the servo.
® are included with the kit to secure
® in the forward slots. Other size
❏
7. Install a longer servo arm on the rudder servo. The arm
must be long enough so that you can install the screw lock
connector into a hole approximately 1/2" [13mm] from the
center of the servo spline. Install the screw lock connector,
retainer and 2-56 x 3/16" [2mmx 4.8mm] screw and then install
the rudder servo into the tray using the same technique used
for the elevator servo.
❏
8. Cut off the excess pushrod wire, leaving 1/4" beyond
the connector.
❏
9. Install the remaining self adhesive Velcro to the back of
your receiver and the plywood tray as shown.
15