Assembly; Seat Installation - Pride Mobility Jazzy 1120 Owner's Manual

SEAT INSTALLATION

(Seat with H-frame)
The standard seat installation method incorporates the seat frame
(H-frame) and four (4) adjustable seatposts located on the powerbase.
To install the seat:
1. Set the seat on the rear seat towers. See figure 9.
2. Push the seatback and down until the latches engage on the front
seat towers. See figure 10.
3. Plug the controller cable into the connector on the utility tray.
See figure 11.
4. Plug the power seat switch cable (if so equipped) into the
connector on the utility tray.
5. Secure the controller cable to the armrest receiver with one or
more wire ties.
6. Route the cable to ensure that the cable cannot be pinched in the
seat hinge.
(Seat with Euro H-frame)
1. Remove the shroud.
2. Remove the seat tower pins. See figure 12. You may need to
rotate the pins back and forth to remove them.
3. Insert the neoprene O-ring onto the seat tower receiver. See figure 13.
4. Insert the seat tower receiver into the frame.
5. Fasten the external snap-ring onto the end of the receiver so that
it seats into the groove. You can use your fingers to pull the
snap-ring into place. You may need to remove the front battery if
you want to use external snap-ring pliers.
6. Replace the shroud.
7. Insert the seat towers into the seat tower receivers.
8. Insert the joystick into the mounting bracket and adjust the length.
SEAT TOWER PINS
Figure 12. Seat Tower Pins
Jazzy 1120
I V . A S S E M B L Y
SLIDE SEAT ONTO REAR SEAT TOWERS
Figure 9. Rear Seat Towers
LOCK SEAT INTO PLACE HERE
Figure 10. Front Seat Towers
PLUG IN CONTROLLER CABLE
Figure 11. Controller Cable
SEAT TOWER RECEIVER
EXTERNAL
SNAP-RING
Figure 13. Insert the Neoprene O-ring
NEOPRENE O-RING
13