Assembly - Pride Mobility Jazzy Air 2 Owner's Manual

INITIAL ASSEMBLY
Your power chair may require some assembly either before initial use or after transportation. It may also require
disassembly to make some comfort adjustments.
Seat Installation
It may be necessary to install the seat either prior to initial operation or after transporting your power chair.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be reused as it may cause damage
to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local
hardware stores or through your authorized Pride Provider.
To install the seat:
1. Remove the shrouds from the power chair.
2. Remove the right battery cover.
3. Connect the battery.
4. Press the on/off button to power on controller.
5. Press actuator button. The Mode LED should
illuminate.
6. Using the controller, raise the actuator to highest
position.
7. Press the on/off button to power down.
8. Place the seat onto the seat plate.
WARNING! Do not pick up the seat
frame by the armrests. They are free
to pivot, and you may lose control of
the seat if they do so.
9. Tip the seat backward. Insert the front bolt with
washer through the slot in the seat plate and align
with tapped hole in the underside of the seat. Start
tightening by hand, leaving the bolts loose. See
figure 10.
10. Repeat step 9 for other side.
11. Slide seat forward or backward to align rear bolt
holes with washer to the desired position. Start tightening by hand.
12. Tighten all of the bolts with the provided hex key.
13. Place armrests into the receivers and tighten setscrews at desired height.
14. Place the headrest into the back of the seat and adjust to the desired height.
15. With the armrest lowered, install the controller on the desired armrest. Adjust the controller to the desired
position and then tighten setscrew.
16. Route the controller and lighting harnesses along the inside of the armrest.
17. Secure the harnesses on the armrest with the supplied wire-ties as shown in figure 11.
18. Flip up the armrest.
19. Secure the harnesses along the armrest receiver and seat plate with supplied wire-ties as shown in figure 11.
20. Ensure the armrest can freely be raised and lowered without any tension on the harnesses so they do not
become disconnected.
Jazzy Air® 2
I V. A S S E M B L Y
Figure 10. Seat Installation
www.pridemobility.com 15