Enabling And Disabling Parksense; Service The Parksense® Rear Park Assist System - Dodge Challenger SRT Hellcat 2015 Owner's Manual

Enabling And Disabling ParkSense®
ParkSense® can be enabled and disabled with the
ParkSense® switch, located on the switch panel below
the Uconnect® display.
When the ParkSense® system is disabled, the
Drivers Information Display (DID) will display
the "PARKSENSE OFF" message for approxi-
mately five seconds. Refer to "Drivers Informa-
tion Display (DID)" in "Understanding Your Instrument
Panel" for further information. When the shift lever is
moved to REVERSE and the system is disabled, the DID
will display the "PARKSENSE OFF" message for as long
as the vehicle is in REVERSE.
The ParkSense® switch LED will be ON when
ParkSense® is disabled or defective. The ParkSense®
switch LED will be OFF when the system is enabled. If
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 187
the ParkSense switch is pressed and the system is dis-
abled or requires service, the ParkSense switch LED will
blink momentarily and then the LED will be ON.
Service The ParkSense® Rear Park Assist
System
During vehicle start up, when the ParkSense® Rear Park
Assist System has detected a faulted condition, the
instrument cluster will actuate a single chime, once per
ignition cycle and it will display the "PARKSENSE
UNAVAILABLE
"PARKSENSE UNAVAILABLE SERVICE REQUIRED"
message for five seconds. Refer to "Driver Information
Display (DID)" in "Understanding Your Instrument
Panel" for further information.
When the shift lever is moved to REVERSE and the
system has detected a faulted condition, the Driver
Information Display
"PARKSENSE UNAVAILABLE WIPE REAR SENSORS"
I n f o r ma t i o n P r o v i d e d b y :
WIPE REAR SENSORS"
(DID) will display
3
or
the