Enabling And Disabling Parksense; Service The Parksense Rear Park Assist System; Cleaning The Parksense System - Dodge CHALLENGER 2020 Owner's Manual

196 STARTING AND OPERATING
E A D
NABLING ND ISABLING
ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the Uconnect display.
When the ParkSense switch is pushed
to disable the system, the instrument
cluster will display the "ParkSense
Off" message for approximately five
seconds. When the gear selector is moved to
REVERSE and the system is disabled, the
instrument cluster display will display the
"ParkSense Off" message for as long as the
vehicle is in REVERSE.
Refer to "Instrument Cluster Display" in
"Getting To Know Your Instrument Panel" for
further information.
The ParkSense switch LED will be on when
ParkSense is disabled or defective. The
ParkSense switch LED will be off when the
system is enabled. If the ParkSense switch is
pushed and the system is disabled or requires
service, the ParkSense switch LED will blink
momentarily and then the LED will be on.
P S S T
ARK ENSE ERVICE
A S
SSIST YSTEM
During vehicle start up, when the ParkSense
Rear Park Assist System has detected a faulted
condition, the instrument cluster will actuate a
single chime, once per ignition cycle and it will
display the "PARKSENSE UNAVAILABLE WIPE
REAR SENSORS" or "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message
for five seconds. Refer to "Instrument Cluster
Display" in "Getting To Know Your Instrument
Panel" for further information.
When the gear selector is moved to REVERSE
and the system has detected a faulted
condition, the instrument cluster display will
display the "PARKSENSE UNAVAILABLE WIPE
REAR SENSORS" or "PARKSENSE
UNAVAILABLE SERVICE REQUIRED" message
for as long as the vehicle is in REVERSE. Under
this condition, ParkSense will not operate.
P S R P
HE ARK ENSE EAR ARK
If "PARKSENSE UNAVAILABLE WIPE REAR
SENSORS" appears in the instrument cluster
display, make sure the outer surface and the
inside of the rear fascia/bumper is clean and
clear of snow, ice, mud, dirt or other
obstruction, and then cycle the ignition. If the
message continues to appear see an
authorized dealer.
If "PARKSENSE UNAVAILABLE SERVICE
REQUIRED" appears in the instrument cluster
display, see an authorized dealer.
C T P S
LEANING HE ARK ENSE
Clean the Rear Park Assist sensors with water,
car wash soap and a soft cloth. Do not use
rough or hard cloths. In washing stations, clean
sensors quickly keeping the vapor jet/high
pressure washing nozzles at least 4 inches
(10 cm) from the sensors. Do not scratch or
poke the sensors. Otherwise, you could damage
the sensors.
S
YSTEM