Panasonic KX-T336200 Installation Instructions Manual page 94

2.05 Call Forwarding to Trunk
Description
Call Forwarding to Trunk allows extension users
who are away from their phones to receive
incoming calls (both CO and extension) at outside
place.
When an incoming CO call is forwarded to the
pre-assigned outside party by this feature, CO to
CO call via this system is established. Duration
Trunk Group," CO-CO Duration Limit of receiving
CO line. The system sends alarm tone to both
parties 15 seconds before the Duration Limit time
is expired, and when expired the system
disconnects both parties compulsively.
The following incoming calls do not receive Call
Forwarding treatment.
A call from doorphone
l
A call routed via DIL 1: N feature
l
A call directed to a UCD group
l
To set Call Forwarding to Trunk, assign both
"System-Class of Senrice",
Not Disturb and CO Forward Mode to
To set and cancel this function, dial the feature
number for "Call Forwarding-To Trunk' and "Call
Forwarding/Do Not Disturb Cancel."
Programming
System Programming
'System-Class of Service (l/2)",
Call Forwarding/Do Not
Disturb
CO Forward Mode
"System-Numbering Plan
Call Forwarding-to Trunk
Plan
Call Forwarding/Do Not
Disturb Cancel
"Group-Trunk Group (l/2)",
CO-CO Duration Limit
Call Forwarding/Do
Reference
VT I Dumb
lo-c-7.00
Q-D-4.01
9-D-6.04 lo-c-10.00
Q-D-6.05 lo-c-10.00
9-E-1 .Ol 10-c-14.00
6-D-16
(70695)
Conditions
An extension user may have only one type of
Call Forwarding/Do Not Disturb feature in effect
at any time. If a second type is assigned, the
previously assigned type is canceled.
The Operators (Attendant Console or Extension)
can cancel the Call Forwarding/Do Not Disturb
feature assigned to the extension users. Refer to
Section 5-G-9.00 "Remote Station Feature
Control."
Up to 32 digits composed of "0 through
the destination. CO line access code must be
entered as the leading digit of each entry.
Note:
If CPC signal is not
supplied
l
Office in your area, KX-T336 cannot detect the
end of CO-CO call after one party disconnets
the call.
In this case, we recommend to use tone
detection feature of AGC Card (See Section 1 O-
C-67.00 'DISAIAGC Tone Detection Mode
by the Central