Panasonic KX-T336200 Installation Instructions Manual page 91

1.06 Screened Call Transfer to Trunk
Description
Allows an extension user to transfer calls (both
extension and outside) to an outside party with
announcement.
Available when "SLT Transfer Operation" is set to
"Mode 2".
To execute this function, assign 'System-Class of
Service", CO Transfer mode to "Yes."
If outside call is transferred to another outside
party, CO-CO conversation mode is established
and the duration of the conversation
by "Group-Trunk Group", CO-CO Duration Limit.
Programming
System Programming
"System-Class of Service (l/2)",
CO Transfer Mode
"System-Numbering Plan (1
Transfer
Group
CO-CO Duration Limit
"World Select 3 (WS3)"
SLT Transfer Operation
Conditions
If a call from outside party is transferred to
another outside party, CO-CO conversation
mode is established. In this case, the system
uses the preset time limit for the trunk group that
the transferred party is placed on,.not using the
time limit for the trunk group used to call the
destination and alarm tone is sent to parties 15
seconds before the assigned time limit, and when
time is out, both CO lines are disconnected.
The extension users can not transfer the
following calls.
A call with Attendant Console
l
A call with Doorphone
l
If Music on Hold is available, from the start of the
transferring operation until the destination party
answers, the system sends Music on Hold to the
transferred party.
For further detail, refer to Section 3-E-l .OO
"Music on Hold."
While having a conversation;
is restricted
9-D-6.11
Note:
*If an extension that cannot execute this function
l
5-D-3-3
(70695)
Operation (Mode 2)
1. Press the switchhook for
approximately one half second
and release it.
The other party is placed on
l
Consultation
You hear confirmation tone 2
l
and then dial tone 1 or 3 or 4.
2. Dial the feature number for
Transfer "58" (Default).
and then dial tone.
You hear ringback tone from _
l
the CO line.
4. When the destination answers,
make the announcement.
5. Replace the handset.
The call is transferred to
l
the destination.
(by COS restriction) attempts to do this
procedure, the system sends a consultation hold
recall to the extension after step 5 and the
transfer is rejected.
switchhook for approximately one half second
and release it before the destination answers.
If CPC signal is not supplied by the Central
Office in your area, KX-T336 cannot detect the
end of CO-CO call after one party disconnects
the call. In this case, we recommend to use
tone detection feature of AGC Card (See
Section 1 O-C-67.00 'DISAIAGC Tone Detection
Mode (TOM)").
Hold.