Panasonic KX-T336200 Installation Instructions Manual page 211

Item
Assigning Items
0 8
CPC Detection
09
1 0 Start Arrangement
11 Wink Signal Time-Out
Conditions
Before setting this screen, "Trunk Group
This cannot be programmed if no CO trunk card is assigned in
"Slot Assignment (SLA)." If any one of the cards is programmed, this screen
be programmed.
If the "Trunk Group (TGl)" containing .the CO line has "Type" assigned to '6 (DID),"
or '7 (TIE)" the following items cannot be entered :
Direct Termination
l
Night Answer Point (Type : No)
l
CPC Detection
l
If the Trunk Group (TGl)" containing the CO line has "Type" assigned to anything other than '6 (DID)," or
Start Arrangement
l
Item
Number
Direct Termination
0 3
Night Answer
04
Point (Type : No.)
Dial Type
05
1 : 60% break
2 : 67% break
(Not assignable when the dial type is DTMF)
00: none
01 : 6.5 ms detection
02 to 75 : 8N ms detection
(Not assignable when the Trunk Group type is DID or TIE)
1 : immediate start
2 : delayed wink start
(Assignable when the Trunk Group type is DID or TIE)
1 : 64ms
2 : 128ms
127 : 8.128 s
** " is displayed-:
l
** " is displayed :
l
Wink Signal Time-Out
l
This is assignable only when the Trunk Group (TGl)" containing the CO
line has 'Incoming Mode (Day)" assigned to
is displayed and setting is impossible.
This is assignable only when the "Trunk Group
line has 'Incoming Mode (Nightr assigned to "2 (Fixed)" or 3 (Flexible)."
Otherwise, U *+* n is displayed and setting is impossible.
is assigned to '2 (Fixed)."
If "Pulse mode" is selected, refer to Section 10-C-51 .OO "World Select 1
Interdigit Pause
l
Pulse Type
l
% Break Detect
l
lo-C-35
(70695)
Input Value
can
Continued