Unclogging Spray Tip/Guard Assembly - Graco 16F887 Operation Manual

Unclogging Spray Tip/Guard Assembly

Unclogging Spray Tip/Guard
Assembly
Do not operate or spray near children. Do not aim the
sprayer at, or spray any person or animal. Keep hands
and other body parts away from the discharge. For
example, do not try to stop leaks with any part of the
body.
1. To unclog tip obstruction, engage trigger lock and
put prime/pressure relief valve UP to release pres-
sure.
ti16699a
ti14994a
2. Reverse spray tip to UNCLOG position.
ti14991a
ti14991a
3. Aim sprayer at waste area, disengage trigger lock,
and put prime/pressure relief valve DOWN to spray
position. Pull trigger to clear clog.
ti16698a
ti14995a
4. Engage trigger lock. Put prime/pressure relief valve
UP to release pressure and rotate spray tip back to
SPRAY position.
ti14994a
ti16700a
16
ti16700a
ti14999a
ti16701a
ti15425a
ti14999a
ti16992a
5. Disengage trigger lock, put prime/pressure relief
valve DOWN to spray position, and resume spray-
ing.
ti16698a
ti14995a
6. If tip is still clogged, you may have to repeat steps
1 - 5 and rotate the tip from SPRAY to UNCLOG
several times. Repeat step 1 to release pressure,
remove and clean filter, or replace with new tip
assembly.
ti14989a
ti14989a
NOTE: Filter assembly is reverse-threaded:
Turn left (or counter-clockwise) to install.
Turn right (or clockwise) to remove.
Make sure filter is completely screwed into the Tip/Guard
Assembly to avoid damage to the filter. Do not use a
damaged filter or poor sprayer performance may result.
7. When obstruction is cleared, engage trigger lock
and rotate arrow-shaped handle back to SPRAY
position.
ti16699a
ti16701a
ti15425a
NOTICE
ti16992a
ti14985a
ti14994a
3A1698G