Unclogging Spray Tip/Guard Assembly - Graco 16H960 Operation, Parts, Repair

Unclogging Spray Tip/Guard
Assembly
Always perform the Pressure Relief Procedure
(page 9) before unclogging spray tip.
1. To unclog tip obstruction, engage trigger lock and
put prime/pressure relief valve UP to relieve pres-
sure.
ti19350a
2. Reverse spray tip to UNCLOG position.
3. Aim sprayer at waste area, disengage trigger lock,
and put prime/pressure relief valve DOWN to spray
position. Pull trigger to clear clog.
ti19374a
4. Engage trigger lock. Put prime/pressure relief valve
UP to relieve pressure and rotate spray tip back to
SPRAY position.
ti19350a
18
ti19347a
ti19370a
ti19346a
ti19347a
ti19371a
5. Disengage trigger lock, put prime/pressure relief
valve DOWN to spray position, and resume spray-
ing.
ti19374a
6. If tip is still clogged, it may be necessary to repeat
steps 1 - 5 and rotate the tip from SPRAY to
UNCLOG several times. Repeat step 1 to release
pressure, remove and clean filter, or replace with
new tip assembly.
7. When obstruction is cleared, engage trigger lock
and rotate arrow-shaped handle back to SPRAY
position.
ti19350a
Operation
ti19346a
ti19349a
ti19371a
3A2308A